S&S Cycle 635 H.O. Easy Start Cam Kit For Harley Twin Cam 2006-2017

S&S Cycle 635 H.O. EZ Easy Start Cam Kit For Harley Twin Cam

If you’ve put together a hot bike – or if reliability is paramount – an S&S Easy Start Cam Kit should be on your list. Don’t bother fooling with compression releases or massive-output batteries and super-high-buck starters. S&S designed the Easy Start cams with performance in mind, but then revamped the design to give you great power on a cam that starts easier than a dirtbike. At the center of the cam lives a centrifugally retracted, spring loaded compression release lobe milled into the heel of each exhaust lobe. At cranking speeds, the lobe bumps the exhaust valve open slightly during the compression stroke, making the engine much easier to turn over. Once the engine fires and reaches 800 RPM, the lobe swings out of the tappet roller path, allowing the engine to run normally and with full compression. Ain’t technology great?

Features:

• Start any engine regardless of displacement or compression ratio with a stock starter
• Save your starter and battery; tested for 10,000 starts without running battery down
• Allows for easy start by initially reducing cranking compression, but once the engine starts and rpm increases, the compression release lobe is centrifugally retracted and the engine runs normally, with full compression, and without any loss in performance
• Only available in chain drive version
• All chain drive cams include installation kit
• Made in the USA

635 H.O. Cam Info:

• High power cam for modified engines: increased compression, high-lift valve springs and large bore throttle body required
• For best results, ported heads and low-restriction intake/exhaust are also required
• 4000 RPM-6500 RPM
• Intake open/close 19.5°/43.5°
• Exhaust open/close 58.5°/37.5°
• Intake duration 243°
• Exhaust duration 276°
• Lift .635″